• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

How to Replace a Nissan Juke Spare Key

Nissan Juke is an attractive and enjoyable hatchback with unique engine design. It's not the most quiet, however it's still a fun car to drive.

Replace the key fob battery of your Nissan Juke every two years or when it's at a low. You can do it yourself, however you'll need tools.

Dead Coin Battery

If the key fob on your Nissan New Key Fob Juke is not functioning, make sure you check the battery for coins. It may be dead and needs to be replaced. This is a quick fix that will take only some minutes. Flip the fob upside down so that you'll be able to see the tiny latch/release located at the back. Replace the battery you have previously installed with the new one, making sure it's on the bottom of the fob. Place the two halves in a careful manner.

The fob needs to be cleaned if it has been exposed to water before you can install a new battery. This can be accomplished by using a paper towel, isopropyl alcohol or electronic cleaner, and allowing it to dry completely before re-inserting battery.

The key fob needs to be connected with the vehicle to be able to start the car. This can be done by following the directions in the owners manual or using an OBDII scanner. If the key fob is not been connected, this is the most likely cause of why it stopped working. It could also be that the fob is equipped with a faulty chip, but this is not common. In this case, a new receiver module could be needed. If this is the scenario, it's going to need to be replaced by a certified technician.

Water Damage

Key fobs operate on batteries and the batteries must be replaced every two years or when the vehicle stops responding when you push the "start" switch. The key's rubber seals keep out water, but submerging your key fob in ocean or pool water can harm the chip's electronic. If this is the case you'll have to purchase an alternative key from Nissan or locksmith.

If the key's chip is an operating chip it's likely that the computer has simply lost connection to it, which could happen for any number of reasons. A simple restart of the car can fix this, but should the key be showing the "Key ID" error message, you'll need to contact nissan pulsar key replacement or an auto locksmith for assistance.

The three most common causes of this issue are dead battery on the key fob or keys that are not programmed, and a damaged or malfunctioning key fob that is damaged or faulty. The first two problems are relatively simple to fix and the third one is more difficult to diagnose and fix immediately, but can be resolved with patience. Compare Nissan Key Replacement prices in your area with WhoCanFixMyCar and schedule your repair online. It takes just minutes and you can read reviews of customers from local garages, nissan micra key programming car mechanics and dealerships before you decide.

Faulty Chip

The key fob on your Nissan Juke contains a special chip that transmits a message to the vehicle when you turn it. If the chip is damaged, it can cause the key to cease functioning. If this happens, the problem is only solved by replacing the key. There are many reasons your Nissan Juke's key may be defective, including water damage or a dead coin battery or a damaged receiver module.

Examine the chip for water damage If your key fob has stopped working after a bath or wash. Check that the retaining clips are tight and the chip isn't exposed to water. If you spot any signs of water damage on the electronic component, take off the battery and wipe it down using isopropyl ethanol or an electronic cleaner.

If the chip is not working If the chip is damaged, you'll have to contact your local locksmith or dealer. They will need to know the year as well as the model, make and year of your vehicle to find an alternative. You'll also need note down your VIN (Vehicle ID Number) so that the dealer, or locksmith knows which key you have. This will enable them to look up the correct key code and confirm that they cut the right one.

Faulty Receiver Module

The key fob sends a radio frequency signal to your car in order to perform many functions. The key fob can open your trunk while you hurry to get groceries or even start your car by pressing an icon on the fob. It can also open your windows and turn the horn on in the event you lock your keys in your car.

If the key fob stops working, it could be a problem with the receiver unit in the vehicle. The receiver modules are tuned so they can detect specific frequencies which correspond to the signals sent by Nissan key fobs. If your car is equipped with a faulty receiver module is damaged, it will cease to respond to any signal received from the key fob.

No matter how your Nissan key fob ends up getting damaged, it is always important to have a spare key in case the key gets damaged or lost. A locksmith or a dealership can program an additional key to work with your Nissan. This will save you from the hassle of losing your keys or locking them in your car.

If your Nissan Juke key fob was exposed to clean water from the tap or rain The issue could be cleaned with isopropyl alcohol or electronic cleaner. If, however, the chip has deteriorated then you'll need purchase a new key fob, which can be assigned to your vehicle by a locksmith dealer.